2.5U 110Vdc 20A rectifier module

RM11020-B is a power supply device that converts standard AC voltage into stable 110Vdc for communication power supply system.

For a larger load capacity, the rectifier modules can be connected in parallel, or an additional independent monitoring module can be used for intelligent control.The rectifier module is a plug-in modular unit designed to be compatible with racks and cabinets.

Electrical Specification

1.1 Input Feature

1.2 Output Feature

1.2.1 Output voltage current regulation

1.2.2 Output ripple and noise

Note： Ripple and Noise testing:Ripple and noise Default as 20 MHz

1.2.3  Output dynamic response

Note：Adjustment slope Cycle 4ms .

1.2.4 Output Overshoot

Note：Loading Range :Minimum to maximum.

1.2.5 Power Switch Point

  Input Voltage -- Power Capacity

Output Current --Output Voltage

1.2.6 Power on output delay time

1.2.7 LED Indicator

The power LED is installed on the power panel side and the output status is shown in the table below.

1.2.8 Fault Display

The module alarm information is flashed in real time on the LED in the form of a fault code. The fault code is shown in the following table.

1.2.9 Communication function of Rectifier module and Monitor Control Module

Rs485 Interface , Rectifier module and Monitor control Module  

The 485 interface of the rectifier module application with isolated .

Main function of  Rectifier module communication ：

1、Remote communication

The module's protection signals (input fault, over temperature, output overvoltage, over-current, etc.) and fault signals will  be transmitted to the monitoring unit.

2、Remote detection

Detect rectifier module output Voltage 、Current will be reports to Monitor module

3、Remote control

According to the monitor Control Module Orders,Control Rectifier module ON/OFF, Float Charge and Equ--charge and Charge switching.

4、Remote adjust

According to the monitor control module orders , adjust rectifier module output Voltage,and adjust the Output current limited current point between 10%~ 100% .

1.3 Protection Function

1.3.1Output Limited Current Protection

1.3.2 Output Circuit Protection

1.3.3 Output Over Voltage

Note：Under Locked Status,need to Disconnect AC Power firstly, then Connect AC power again, rectifier module will be working again )

1.3.4 Input Over Voltage Protection

1.3.5 Input Under Voltage Protection

1.3.6 Over-Temp. Protection

1.3.7. Size

H×W×D：102mm×114mm×293mm